Solar Snake Repeller

Solar Snake Repeller - WK2030

The Solar Snake Repeller WK2030 is designed to repel snakes, by emitting a pulse which snakes feel as a vibration transmitted through the ground. Snakes then perceive a danger zone causing them to evacuate the area.

• The Solar Snake Repeller transmits its signal in all directions approx 20 m.
• Coverage area 450 - 600 m2.
• If you need to protect a larger area, install more units. They can placed approx 40 m apart to get optimum coverage. It is always recommended to use two or more units to get the best results.
• The repeller works with rechargeable batteries. The solar module runs the unit and charges the battery during the day, night-time operation is enabled by the batteries.

Solar Snake Repeller - Installation

• Press “ON” under the head of the unit.
• Attach the small connectors on the wires from the base of the head of the unit to the one from the spike section, and attach the spike to the head of the unit.
• Insert the spike into the ground paying attention not to damage the unit.
• The spike should be firmly planted while leaving the base of the head minimum 2.5 - 5 cm above the ground
  • We suggest use a crowbar to first make a small hole and gently push the spike in or dig a small hole and backfill with earth after the unit is in place.
  • Do not use a mallet, hammer or excessive force as this may damage the unit.
• As long as you can get the unit 2/3rds of the way into the ground with firm ground contact, is good.
• You can tell the Solar Snake Repeller is operating, as its led light will flash as it transmits its signal, you will feel the vibrations.

Solar Snake Repeller - Maintenance

• Sometimes the unit may need a short time in the sun to give them a boost and start up, when first installed.
• If the unit stops operating, check/change the rechargeable batteries to see that it is OK.
• Although the units are weatherproof, it is recommended that you remove it under extreme weather conditions such as hail, flooding and snow.
• The only maintenance required is with a soft cloth, wipe the solar panel cover to remove any excess dirt and grime.
• Relocate the Solar Snake Repeller from time to time. Moving them 3-4 meters, every 2-3 months should be enough to prevent habituation.